Manual 01 - Buttons Housing (Power & Volume)

Power down device.

Remove SIM Card and Tray. Place both in COMPARTMENT A.

Insert a guitar pick at the bottom of the SIM tray opening to begin removing the battery cover.

Continue peeling the battery cover away with your fingers.

Place the battery cover in ZONE I.

Remove eleven 3.8 mm #00 Phillips screws (silver). Place in SLOT 1.

Remove one 2.5 mm #00 Phillips screw (black). Place in SLOT 2.

Wedge the flat end of the spudger under the right edge of the rear housing. Slowly twist the spudger while lifting the housing with your fingers.

Place rear housing in ZONE II.

Replace rear housing from ZONE II:

Snap it into place at the top of the phone.

Replace one 2.5 mm #00 Phillips screw (black) from SLOT 2.

Replace eleven 3.8 mm #00 Phillips screws (silver) from SLOT 1.

Replace the battery cover from ZONE I:

Snap the top and bottom into place. Check around the perimeter to ensure all edges are snapped into place.

Replace the SIM Card and Tray from COMPARTMENT A.

Power up and test the device.