Manual 03 - Volume Rocker

Power down the device.

Remove battery cover and battery. Place in ZONE I.

Remove SIM card and SD card. Place in COMPARTMENT A.

Remove ten 4.0 mm #00 Phillips screws. Place in SLOT 1.

Use curved-tip tweezers to pull free any screws that get stuck.

Picture 1: On the volume rocker side, near the bottom, push the blue pry tool between the front panel and mid-frame.

Picture 2: Sweep up to the top.

Turn the phone face up and insert the blue pry tool in the upper-right corner.

Slowly work your way down the side.

Continue peeling the mid-frame away from the front panel with your fingers.

Put the mid-frame in ZONE II and front panel in ZONE III.

Picture 1: Push volume rocker towards the inside of the mid-frame.

Picture 2: Make sure you don't tear the rubber attachment head as you carefully peel up from the mid-frame.

Place in COMPARTMENT B.

Picture 1: From COMPARTMENT B, push volume rocker into place with curved-tip tweezers.

Picture 2: Seat rubber attachment head over tab as shown in red square.

Picture 1: Line up mid-frame with front panel. Seat bottom near charging port first.

Picture 2: Work your way to the top.

Picture 3: Check the perimeter to make sure all edges are snapped into place.

Replace ten 4.0 mm #00 Phillips screws from SLOT 1.

Replace SIM and SD cards from COMPARTMENT A.

Replace battery and battery cover from ZONE I.

Power up device and test replacement part or parts.